scale-the method of removing scale
Due to the long-term water flow in the shower, due to the water quality. Due to environmental factors, a certain amount of scale and impurities will be generated inside the shower. The accumulation of scale and impurities to a certain extent may affect the comfort of your bathing, and even have a destructive effect on the shower. When removing scale, remove the shower head and place it in a small basin every six months or less, water the surface and inside of the shower head with edible white vinegar and soak for 4-6 hours, and then gently use a cotton rag Wipe the spout on the surface of the shower head: After reinstalling the connector, let the water flow for a while, and wait for the white vinegar and scale to flow out with the water to eliminate or reduce the influence of scale on the shower and have a certain sterilization effect. For the cleaning of the electroplating surface of the faucet, you can often wipe the electroplated surface of the shower with a soft cloth and a little flour, and then rinse with water to make the surface of the shower bright as new.
Shower head scale-precautions for removing scale
When disassembling the shower head, please pay attention to your own safety and the safety of the product; do not use the filter gasket with too large or too fine mesh, too large may not have a filtering effect, too fine may affect the flow rate, the filter specifications are 40-60 mesh is appropriate. Do not use strong acid when removing limescale to avoid corrosion on the shower surface. Do not disassemble the shower head for maintenance by yourself. Improper disassembly will damage the appearance and internal structure of the product. The ambient temperature of the shower head should not exceed 70C. High temperature and ultraviolet light will greatly accelerate the aging of the shower head and shorten the service life of the shower head. Therefore, the installation of the shower head should be as far away as possible from the heater and other electrical heat sources. The shower head cannot be installed directly under the Yuba, and the distance should be above 60cm.